0805inch/2012mm SMD BLUE CHIP LED

2012/0805 smd chip led with low power consumption various colors/wide viewing angle/Pb-free/within RoHS complaint version

2012/0805 smd chip led with low power consumption and wide viewing angle

Features

 

1.Package in 8mm tape on 7 diameter reel.

2.Compatible with automatic placement equipment.

3.Compatible with infrared and vapor phase reflow solder process.

4.Mono-color type.

5.Pb-free

6.The product itself will remain within RoHS complaint version

Descriptions

 

1.The 0805inch  SMD LED is much smaller than lead frame type components, thus enable smaller board size, higher packing density, reduced storage space and finally

smaller equipment to be obtained.

2.Besides, lightweight makes them ideal for miniature applications, etc.

 

Applications

 

1.Backlighting in dashboard and switch.

2.Telecommunication: indicator and backlighting in telephone and fax.

3.Flat backlight for LCD, switch and symbol.

4.General use.

Label explanation

  CAT: Luminous Intensity Rank

  HUE: Dom. Wavelength Rank

  REF: Forward Voltage Rank

Reel Dimensions 

Carrier Tape Dimensions: Loaded quantity 3000 PCS per reel

Moisture Resistant Packaging

Precautions For Use

 

1. Over-current-proof

Customer must apply resistors for protection , otherwise slight voltage shift will cause big current change ( Burn out will happen ).

 

2. Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package: The LEDs should be kept at 30°C or less and 90%RH or less.

2.3 After opening the package: The LED's floor life is 1 year under 30°C or less and 60% RH or less. If unused LEDs remain, it should be stored in moisture proof packages.

2.4 If the moisture absorbent material (silica gel) has faded away or the LEDs have exceeded the storage time, baking treatment should be performed using the following conditions. Baking treatment : 60±5°C for 24 hours.

 

3. Soldering Condition

3.1 Pb-free solder temperature profile

3.2 Reflow soldering should not be done more than two times.

3.3 When soldering, do not put stress on the LEDs during heating.

3.4 After soldering, do not warp the circuit board.

 

4.Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 350°C for 3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.

5.Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.

0805inch/2012mm SMD BLUE CHIP LED